Configure NetFlow - Riverbed Steelhead
Posted: Sun Jun 20, 2010 4:42 pm
Riverbed Steelhead appliances for WAN acceleration also support NetFlow.
Below are the basic commands assuming that the defaults are taken:
(config)# ip flow-export destination
<ip-addr> interface <int #>
(config)# ip flow-export enable
Further details can be found at https://www.riverbed.com/products/appliances/
Below are the basic commands assuming that the defaults are taken:
(config)# ip flow-export destination
<ip-addr> interface <int #>
(config)# ip flow-export enable
Further details can be found at https://www.riverbed.com/products/appliances/